Smart self-propelled remote control lawn mower
Before the lawn mower goes to work, a series of inspections and preparations must be carried out. Stop the machine at a horizontal position, first check the fuel tank and cooling water tank, open the water tank cover, add an appropriate amount of cooling water according to the manual requirements, cover the water tank cover, open the fuel tank cover, and add fuel that meets the requirements, do not overfill the fuel , cover and tighten the fuel tank cap, check whether the tire pressure is normal, inflate it in time if it is insufficient, check whether the cutting disc is operating normally, whether the cutting knife is in good condition, there should be no cracks in each transmission belt, and the pressure pulley works effectively, otherwise it should be replaced in time or adjust.
Put the gearbox clutch handle and cutter clutch handle in the separate position, put the gear handle in the neutral position, loosen the cutter pinch pulley, put it in the walking position, put the throttle handle in the middle position, and start the engine with the crank , after starting, slowly increase the accelerator, and push the gearbox clutch handle to the combined position. Then connect the low-speed forward gear, and the lawn mower starts to walk. When working in a place close to the village, the lawn mower can walk to the destination by itself, because the walking speed of this lawn mower is relatively slow. far, there should be transportation
Hot Tags: smart self-propelled remote control lawn mower, China smart self-propelled remote control lawn mower manufacturers, factory, Lawn Mower, Lawn Mower Machine
